Sightseeing lift

Serial Number  Function Name                         Function Description                                Notes  

 1    Inspection Operation             When the elevator enters inspection mode, the car moves in point operation at inspection speed (less than 0.63m/s)                  

 2    Emergency Electric Operation         Used only on the control cabinet in emergency situations, with running speed and mode the same as 'Inspection Operation'                

 3    Automatic Operation             In unmanned mode, the elevator automatically completes closing doors, starting, stopping, and opening doors according to passenger instructions, delivering passengers to their destination                                                        

     (Unattended)            

 4    Attended Operation           The elevator is operated by a driver, who gives internal selection and door closing commands according to passenger requirements, and the elevator proceeds to the destination as per the commands          

 5    Power-On Automatic Door Opening         Each time the elevator is powered on, if the car is exactly in the door zone, the car doors will automatically open                               

 6    Automatic Door Holding Delay         When there are only internal selection signals, the door holding time after stopping is t seconds (set time); when there are only external call signals, it is t-2 seconds; when there are both internal selection and external call signals, it is 2t seconds    

     (Door Holding Time)      

 7    Local Call Door Opening         If the elevator has not started and the doors are closed or closing, pressing the local call button will automatically open the car doors                

 8    Touch Plate or Light Curtain Protection       When the safety touch plate or light curtain acts during door closing, the door closing action stops immediately, and the doors reopen before closing again              

 9    Full Load Direct Drive             When fully loaded, the elevator only responds to internal selections and not to external calls                                          

10    Overload Stop         If the elevator is overloaded, the doors open, the overload light illuminates, the buzzer sounds, and the operating panel displays 'CZ'                  

11    Running Status Display         Displays elevator running status, direction, floor, car doors, load, faults, etc.                        

12    Lighting Automatic Shutdown         After a specified period of no use, the car interior lighting and fan automatically turn off to save energy                   

13    Fire Return         When the fire switch is closed, the system enters fire operation mode, cancels all calls, drives the elevator to the fire floor station to stop, automatically opens the doors, and outputs a fire linkage signal to the fire control center                                      

14    Automatic Docking During Faults       When a fault occurs during high-speed operation and the elevator stops at a non-door zone, under conditions where the safety circuit is connected and the inverter is working normally, the elevator crawls toward the middle floor direction to level and then opens the doors                                          

15    Standby         After the power lock is closed, the elevator enters standby mode, no longer responding to any external calls, and automatically returns to the locked floor after completing all registered internal selections   

                           Displaying the standby symbol 'ZT'                                               

16    Misoperation Cancellation           If a passenger mistakenly presses an internal selection button and registers it, pressing the same button again cancels the registration                   

17    Anti-Vandalism Function           When lightly loaded, a maximum of 3 internal selections can be registered; additional selections are invalid                                        

18    Button Insertion Self-Diagnosis       If a call button is pressed and not released within 20 seconds, the system considers the button inserted. Thereafter, the corresponding floor call is not registered, and an alarm flashes; when the button is released, the above state is exited       

19    Repeated Door Closing             After executing the door closing command, if the door lock circuit is not conductive within the specified time, the elevator reopens the doors and then closes them again. If this repeats 5 times and the door lock circuit is still not conductive, the elevator stops for repair                                                     

20    Control Cabinet Floor Selection           Internal selections can be registered and door opening/closing commands input via operations on the LCD display                  

21    Arbitrary No-Stop Floor Setting       This function allows users to arbitrarily set no-stop floors according to needs                                   

22    Arbitrary Waiting Floor Setting       In automatic mode, if there are no service calls for a certain period, the elevator automatically...