Fast drying acrylic enamel industrial paint modified rubber anti-corrosive primer MQ10673

Product Description

TYPICAL COATING STRUCTURE

Technical Data Sheet

TOP COATING

Re-coating should be within 16-18 hours depending on conditions prevailing. If too much time is allowed for cure, adhesion can be difficult to obtain on subsequent coats. If too much time has elapsed then the first coat will have to be sanded to provide extra key before the 2ndand 3rdcoats are applied.

NOTE

Do not pour Polyurethane back into the original container. In doing so contamination in particular moisture can be included which will result in a shortened shelf life of the original material.

USAGE RATE

1 X 20Litre drum covers approximately 48 to 100m²(two coats) or as specified depending on surface texture.

LIMITATIONS

Needs moisture to cure hard.Low humidity inhibits cure. When thoroughly dry, a mist of water over the polyurethane will accelerate cure. The use of xylene as a softening agent for re-coating is essential to improve inter-coating adhesion. When resealing Polyurethane, it is advised to lightly sand the old coating to help with adhesion.

STORAGE

Recommends storage in a cool, well ventilated space away from heat sources. Keep tightly lidded. Keep away from reducing agents and strong oxidizing agents. Take precautions against static electricity discharges. See State and Federal Regulations as to storage.

SHELF LIFE

6 months in un-opened container stored as recommended. After this time product should be checked to ensure suitability for use.

DISPOSAL

Contaminated absorbent to be disposed of in a secure land fill in accordance with local bodies , state and or federal authorities.

PRECAUTIONS

After sealing, it is recommended that the sealed surface be protected from foot traffic for a minimum of 48hours. Vehicle traffic for a minimum of 72hours. Time required depends on weather conditions coating thickness etc. Therefore check suitability before allowing traffic.

PRODUCT WARNING

Maiqi Coatings has no control over the use or storage of this product and therefore does not accept any liability in this regard. Any verbal advice given should not be regarded as authoritative information. This information is subject to change without notice, therefore all applicators should ensure they have current information. This product is intended for the use only of skilled tradesmen and where applicable, statutory licensed tradesmen experienced and trained in the use of this product. This product is warranted to be of uniform quality within the manufacturer’stolerance. This manufacturer has no control over the use or misuse of this product, therefore no warranty rests or implied, is or can be made either as to the effects of such use. The manufacturer’sobligations shall be limited to replacing product proving to be defective.

Products Application